oil or gas boiler with price in Ararat

Diqing in Yunnan Nonferrous Metals Co., Ltd. mainly engaged in Pulang copper mining, site selection, sales and other items. As we all know, in the copper smelting process, it consumes a lot of electricity and thermal power resources, which account for most of the hot water consumption. Combined with the actual demand Diqing company, to provide fast Boiler 1 stage electric heating hot water oil or boiler with price in ararat of 2.1MW.

How to improve the thermal efficiency of oil or boiler with price in ararat?

Boiler design efficiency in the engineer design phase, and in general, the actual operation and the initial design thermal efficiency are similar. For example, oil and gas furnace efficiency is greater than 92%, and circulating fluidized bed boiler efficiency is usually higher than 88%. However, boiler efficiency is not fixed. If your equipment is operating at less than design efficiency, then measures can be taken to improve boiler thermal efficiency.

（9）Combustion Adjustment method of Oil-fired Gas-fired Boiler

The combustion adjustment of oil-fired gas-fired boiler is successful and the load adjustment can be carried out after turning into normal operation. At this time, the combustion situation in the furnace should be observed frequently. If the atomization of oil and gas is not good, the flame jumps, the flame hits the furnace tank, and the exhaust temperature is too high or too low, the oil pressure, oil temperature, steam volume, air pressure and steam pressure should be adjusted in time to ensure the safe and economical operation of the boiler. The oil pressure and the pressure are related to the boiler load. The adjustment of the oil pressure is realized by adjusting the pressure of the burner or the amount of oil returned. The adjustment of air pressure is achieved through the opening of the valve. When adjusting a load, enter At the same time, the air volume adjustment must be carried out synchronously to ensure the reasonable match between the oil quantity and the air volume, so as to achieve the purpose of economical operation of the boiler.

Biomass oil or boiler with price in ararat case:

The animal feed plant has a seasonal operation, but a relatively consistent load profile. The peak load is for 850 kg/hour of saturated steam at 8 barg (~650 kW see Figure 3). There is a much smaller load required for longer periods for miscellaneous process steam. The load is currently supplied by a very old light fuel oil (LFO) boiler. The load profile here facilitates an almost complete switch from LFO to biomass. 96% of the steam requirement would be covered by a 650kW biomass boiler. A small oil boiler, or built-in oil burner in the biomass steam boiler would be required to meet the smaller steam loads which would not be met efficiently by the biomass boiler. A straight-forward moving grate boiler with fire-tube heat exchangers can be used. The range of suppliers of biomass steam boiler equipment is limited below 1MW thermal as economies of scale are diminished below this level – a 650 kW boiler costs almost the same as a 1MW boiler.